Filter
Top Products
Specifying input parameters
Using LCDS Print Description Language 2-47
Options
Default No default
SEFFNT command: points to note
Note the following when using the SEFFNT command:
• The system does not assume any mappings for fonts. You
must always provide the mapping. Once the font mapping is
found, range checking is based on the new orientation. The
range checking determines only if the BEGIN values are
within the bounds of the page. The system does not check to
determine whether the line will run off the edge of the page.
• The following system pages use predefined forms and
therefore are not reformatted in order to print the forms in the
same orientation as their associated jobs. In other words, no
font mappings or rotations of forms are performed on the
following files:
– Graphic samples
– Graphic summary pages
– Accounting pages
• Short edge feed (SEF) duplex printing differs from long edge
feed (LEF) applications in that SEF uses a head to toe
orientation for printing portrait pages, while LEF uses head to
head orientation. Refer to the “OUTPUT INVERT” parameter
section of the “Specifying print format parameters” chapter for
alternate methods of rotating the page orientation.
For landscape printing, however, SEF uses a head to head
orientation, whereas LEF landscape uses head to toe
orientation.
Table 2-50. SEFFNT MAP parameter options and definitions
Option Definition
filename References a font mapping file. The file is accessed when the JDL is used for
printing.
label References the label of a labeled SEFFNT command that is defined in the
current JSL.