Filter
Top Products
Using Dynamic Job Descriptor Entries (DJDEs)
Using LCDS Print Description Language 5-71
Options
TOF DJDE
Specifies the number of lines from the top of the logical page to
the first print line (Top Of Form).
Type Record oriented
Syntax TOF = value
Options
TOF DJDE: points to note
• The TOF DJDE is applied before processing of the first data
record following the DJDE record.
• Depending on the time of a page transition, the TOF DJDE
may not take effect on the next record. In other words, even
though a TOF DJDE is processed, a page transition may
have occurred before the DJDE value could take effect.
Table 5-60. TMODE DJDE options and definitions
Option Definition
width The process direction measurement that will be used to determine the pitch
mode.
• For normal (long edge) feeding, this is usually a measure of the short edge
of the widest paper being used in the report.
• For short edge feeding (SEF) this measures the long edge.
Width values can range from the 7 inch equivalent to the 17 inch equivalent.
widthunit Unit of measure for the width of the paper.
Can be IN (inches), CM (centimeters), DOTS, or XDOTS (600 spi dots).
The default width unit is IN.
Table 5-61. TOF DJDE options and definitions
Option Definition
value Specifies the Top Of Form line number. This specification is independent of
channel assignments. It should be greater than or equal to 1 and less than or
equal to the smallest line number assigned to a channel.
The default is 1.