Filter
Top Products
Using Dynamic Job Descriptor Entries (DJDEs)
5-46 Using LCDS Print Description Language
Syntax INKINDEX = {offset, [ZERO | ONE] [, bitopt] | NONE}
Options
INKINDEX DJDE:
point to note
If inks are used:
• If one inkref in the list is omitted, commas must be used as
place holders to maintain the relative positioning of the
remaining ink references.
• If more than two ink references are specified, the additional
ink references are ignored.
INVERT DJDE
Specifies that the subsequent page content will be inverted 180
degrees when printed on the physical page. Portrait oriented text
is printed as inverse portrait, landscape text is printed as inverse
landscape, and vice versa.
Type Page oriented
Syntax INVERT = {FRONT | BACK | BOTH | NONE}
Table 5-35. INKINDEX DJDE options and definitions
Option Definition
offset Indicates the byte offset in the data record where the ink index number is
located.
ZERO Specifies that the first ink in the list is referenced with an index value of 0.
ONE Specifies that the first ink in the list is referenced with an index value of 1.
bitopt bit option
Specifies the number of bits that should be used in calculating the ink index.
The range is 1 through 7.
The default bitopt value is 4.
NONE Specifies that there is no ink index.