Filter
Top Products
Using Dynamic Job Descriptor Entries (DJDEs)
5-72 Using LCDS Print Description Language
For example, if the initial TOF and BOF values are 2 for every
job, a page transition occurs every time a data record is
processed because the TOF and BOF have the same value.
If a TOF DJDE specifying a value of 1 is processed and the
page transition has already occurred, the TOF DJDE value is
too late and does not take effect until the next page transition.
• The value option is defined the same as in the VFU
command, described in the “Specifying print format
parameters” chapter.
• If the value specified in the TOF DJDE is greater than or
equal to the BOF (Bottom Of Form) value, the TOF value is
set to 1.
TRANS DJDE
Specifies whether or not transparencies are used in the print job.
Type Page oriented
Syntax TRANS = {YES | NO}
Options
TRANS DJDE: points to note
• The TRANS DJDE is used to force parameters when
transparencies are used and to minimize paper jams. If
TRANS=YES is specified, the following parameters are
forced:
– DUPLEX=NO
– ACCT=TRAY
– BFORM is ignored.
– For the RPAGE command, the NUBACK parameter is
forced to NUFRONT.
Table 5-62. TRANS DJDE options and definitions
Option Definition
YES Specifies that transparencies are used in the print job.
NO Specifies that transparencies are not used in the print job.