Filter
Top Products
Using Dynamic Job Descriptor Entries (DJDEs)
Using LCDS Print Description Language 5-63
Syntax RTEXT = {NONE | sc | (sc [, {passnum | ALL} [, line [, col
[, fontindex]]]]) | rtextid}
Options
RTEXT DJDE example
RTEXT=(’TEST’,ALL,15,5,2);
END;
Table 5-52. RTEXT DJDE options and definitions
Option Definition
sc string constant
Specifies the message to be printed (a string of 1 to 132 characters). It is
printed with the first font specified in the FONTS parameter of the PDE
command.
Refer to the fontindex option in this table.
passnum pass number
An integer specifying the single copy (pass) to which the text applies. If there
are two or more RTEXT parameters in a ROUTE command, passnum must be
in increasing numeric order.
ALL Specifies that the text applies to all copies.
line Specifies the line number on which the first line of a block of RTEXT message
is printed. To avoid overprinting, only one RTEXT parameter may be specified
per line for a passnum.
The default is line 1 for the first text string of the pass. Otherwise, the default is
the next line of the page.
col column.
Specifies the column number at which the first character of a block of RTEXT
messages is to be printed.
The default is column 1.
fontindex Identifies the index (starting with 1) of the PDE font with which the text is
printed.
rtextid route text identifier
Used to reference a catalogued file of RTEXT parameters previously compiled
by XJDC. A file of the type .TST is referenced.
NONE Specifies that no text is to be printed on a separate page.