Filter
Top Products
Using Dynamic Job Descriptor Entries (DJDEs)
Using LCDS Print Description Language 5-25
Options
DESTINATION DJDE: points to note
• Transparencies should be sent only to the sample tray.
• EXPORT is honored only if the bypass transport is specified
on the LCDS Setup window as the output destination.
DUPLEX DJDE
Specifies whether printing is to occur on both sides of a page
(duplex mode) or a single side (simplex mode). The choice takes
effect on the next page boundary.
Type Page oriented
Syntax DUPLEX = {YES | NO}
Options
Table 5-19. DESTINATION DJDE options and definitions
Option Definition
BIN Specifies delivery to the currently active output bin.
TRAY Specifies delivery to the sample tray.
NOTE: Use caution when selecting the sample tray because of its limited
capacity.
EXPORT Specifies that sheets will be sent to the bypass transport.
Table 5-20. DUPLEX DJDE options and definitions
Option Definition
YES Specifies that printing will occur on both sides of a sheet. (This is also called
“two–sided printing.”)
NO Specifies that printing will occur on only the front side of the sheet. (This is also
called “one–sided printing.”