Filter
Top Products
Specifying print format parameters
4-84 Using LCDS Print Description Language
OUTPUT SYSPPR
parameter: points
to note
• PAPERSIZE=B4 and PAPERSIZE= (10.12, 14.33) produce
identical results in that they indicate long edge feed, as
opposed to short-edge feed format. Refer to the “SEFFNT
command” section in the “Specifying input parameters”
chapter for detailed information on short and long-edge feed.
• The SYSPPR parameter takes effect for the following system
pages:
– DJDE error page (OPRINFO parameter of the IDEN
command)
– Report delimiter page (PRINT parameter of the RSTACK
command)
– Accounting page (ACCT command)
– Graphic error summary page
– Short Edge Feed error page
• SYSPPR and the STOCKSET SYSPAGE parameter:
System pages are checked for stocks through the SYSPAGE
parameter. If there is no stock name active for the current
page, the system checks to see if a stock name was specified
at the user interface on the Stock tab of the queue Properties
window. If so, the system page is printed on the stock that is
specified on the user interface window. If SYSPAGE=stock is
not specified, the MAIN stock definition is used.
SYSPPR defines the paper size to use for the system page.
Therefore, if MAIN contains a mix of USLETTER and
USLEGAL, the system searches for the appropriate feeder
tray that contains the required paper size. If SYSPPR is not
defined, the printer uses the paper size of the current job.
NOTE: SYSPPR defines a paper size, whereas SYSPAGE
defines a stock name reference. Both parameters must
agree in order to prevent errors, similar to the way the FEED
and PAPERSIZE parameters interact.