Filter
Top Products
Specifying print format parameters
4-70 Using LCDS Print Description Language
OUTPUT OFFSET
parameter: point
to note
The OFFSET control of FIRST, ALL, or NONE may be modified
by the ROFFSET command. Refer to the “ROFFSET” command
section in the “Using logical processing” chapter.
If OUTPUT OFFSET=FIRST (or ALL) was specified, and the
ROFFSET criteria is satisfied on the first page of a report, the
normal offset from the preceding report occurs.
OUTPUT OSTK
Specifies that ordered stocks are used for printing the job.
Syntax OUTPUT OSTK = {ostkspec | (ostkspec, ostkspec, ...)}
where ostkspec is:
(stockdef, [mod], [pos], [{RES | NORES}], [TABS], [size {DOTS |
IN | CM}]] [, {L | P}])
Options
Table 4-67. OUTPUT OSTK parameter options and definitions
Option Definition
stockdef stock definition
The identifier or name of the ordered stock to be used, and for which feeder
trays have been identified on the user interface Stock List.
No default.
mod modulus
The number of sheets in the ordered stock. For example, 5 cut tabs would have
a mod value of 5. The range of values is from 1 to 255.
The default modulus definition is 1.
pos position.
The initial position relative to the mod value. The range of values is between 1
and mod.
The default position is 1.
RES
NORES
RESET or NO RESET.
Indicates whether the pos value should be reset at the start of the next report.
The default is RES.
TABS Indicates a tab stock is being used.
The default is no tabs (no option entered).
size Width of the tab. The value can be specified in DOTS, IN, or CM. This
parameter applies only when tabs are specified.
The default is 0.5 in.