Filter
Top Products
Using Dynamic Job Descriptor Entries (DJDEs)
Using LCDS Print Description Language 5-7
Parameters that
can be changed
through a JDE
DJDE
The parameters that can be changed through a JDE that you
specify in a JDE DJDE are listed in the following table.
NOTE: If a front cover is invoked in a selected JDE that takes
effect after the first page of the report, the cover appears at the
point where the DJDE is applied.
Table 5-2. Parameters that are changeable by a JDE DJDE
Command Parameters
ABNORMAL ––
ACCT All parameters
IDEN OPRINFO only
LINE DATA, FONTINDEX, MARGIN, OVERPRINT, PCCTYPE,
VFU
MESSAGE All parameters
OUTPUT All parameters except OFFSET
PDE All parameters
RAUX All parameters
RDELETE ––
RECORD LENGTH
RFEED ––
ROFFSET All parameters
ROUTE All parameters
RPAGE All parameters
RRESUME ––
RSELECT ––
RSTACK TEST
RSUSPEND ––
STOCKSET ––
VOLUME TCODE, CODE