Filter
Top Products
Specifying print format parameters
4-76 Using LCDS Print Description Language
• PAPERSIZE=B4 and PAPERSIZE=(10.12,14.33) produce
identical results because they indicate long edge feed, as
opposed to short edge feed format. Refer to the “SEFFNT
command” section in the “Specifying input parameters”
chapter for detailed information on short and long edge feed.
• To print on B5 and 7 by 10 inch paper sizes, the printer
requires the 7 by 10 inch enablement kit (a hardware option)
to be installed.
• There are performance considerations when you are
switching paper sizes across pitch modes.
• The PAPERSIZE parameter is not supported as a DJDE.
Therefore, a JDE page oriented DJDE that calls out the
desired paper size is needed.
• If the JSL specifies the paper size using the keyword method
(such as USLEGAL, A4, or B4), the form coding must use the
same terminology. If the JSL specifies 8.5,14 and your form
specifies USLEGAL, an error message is displayed,
indicating that the form paper size is too small or too large.
USLETTER and B4 are the only sizes for which the keyword
and the x, y expression do not create any incompatibilities.
OUTPUT
PAPERSIZE
parameter
example
OUTPUT PURGE
Specifies whether or not the system should delete graphic disk
files at the end of report. This is applicable only to documents
with interleaved graphics.
Syntax OUTPUT PURGE = {NO | YES}
OUTPUT PAPERSIZE=USLETTER, FEED=MAIN,
DUPLEX=NO, NUMBER=(1,1,80),
FORMAT=SMPPOE;