Filter
Top Products
Specifying print format parameters
Using LCDS Print Description Language 4-85
OUTPUT TMODE
Specifies a maximum paper width in order to improve throughput
efficiency when mixed paper sizes are used.
Refer to “Paper sizing and print speed” in your printer operator
guide for an explanation of the relationship between paper
widths and throughput speed.
Syntax OUTPUT TMODE = {width | (width [,widthunit])}
Options
Default Based on the specified paper size (expressed in inches)
OUTPUT TMODE
parameter: points
to note
• This feature is not supported for the Nuvera MX systems.
• Width values can range from 7 inches or 178 mm to 17
inches or 432 mm.
• In order to process 7 by 10 inch and B5 papers, the printer
must be configured with the 7 by 10 inch throughput kit (a
hardware option).
Table 4-77. OUTPUT TMODE parameter options and definitions
Option Definition
width The process direction measurement that will be used to determine the pitch
mode.
• For normal (long-edge) feeding, this is normally a measure of the short
edge of the widest paper being used in the report.
• For short-edge feeding (SEF) this measures the long edge of the sheets.
Acceptable values range from the system minimum to the system maximum
(usually specified at system installation).
widthunit Defines the unit of measurement for the default pitch mode. Choices are:
•IN
•CM
•DOTS
•XDOTS.
IN (inches) is the default widthunit.