1–9
USER GUIDE (COPIER)
Paper Trays
Trays 1,2,3 and 4 are located at the lower front of the printer/
copier. Tray 5 (Bypass) is located on the left side of the printer/
copier.
Tandem Tray Module Trays 1and 2 are adjustable from 5.5x8.5 in. through 11x17 in. (A5
through A3) and can accommodate up to 520 sheets based on
paper weight. Trays 3 and 4 are high capacity paper trays and
can accommodate a total of 2000 sheets, 8.5x11 in. (A4 and B5)
based on paper weight.
3-Tray Module Trays 1 through 4 are adjustable from 5.5x8.5 in. through 11x17 in.
(A5 through A3) and can accommodate up to 520 sheets based
on paper weight
Tray 5 (Bypass) Feeds specialty papers i.e. Transparencies, Extra Heavyweight
and non-standard sizes and 12x18 in.
Trays 1 - 4 can feed paper weights 64 to 105 gsm. The machine
automatically detects the size and orientation of loaded paper.
The paper type however must be set on the control panel. Bond
paper is the default setting. Plain or Recycled paper in trays must
be identified on the control panel for maximum efficiency and
image quality. This is set in System Settings mode.
Output Trays
The Center Output Tray delivers output face down, and holds up
to 400 sheets. The Center Output Tray holds up to 200 sheets
when the Finisher (optional accessory) is installed.
The Finisher Tray (optional accessory) holds up to 1000 sheets,
and can staple dual and single staples.
NOTE: The WorkCentre 24 printer/copier should not be moved
after it has been installed. Moving may damage the equipment,
carpet or floor. If equipment must be moved, please contact your
Xerox representative for assistance.