Filter
Top Products
Chapter 7 Interfaces
ZyWALL 110/310/1100 Series User’s Guide
134
Figure 84 Configuration > Network > Interface > Cellular
The following table describes the labels in this screen.
7.5.1 Cellular Add/Edit Screen
To change your 3G settings, click Configuration > Network > Interface > Cellular > Add (or
Edit). In the pop-up window that displays, select the slot that contains the 3G device, then the
following screen displays.
Table 48 Configuration > Network > Interface > Cellular
LABEL DESCRIPTION
Add Click this to create a new cellular interface.
Edit Double-click an entry or select it and click Edit to open a screen where you can modify
the entry’s settings.
Remove To remove an entry, select it and click Remove. The ZyWALL confirms you want to
remove it before doing so.
Activate To turn on an entry, select it and click Activate.
Inactivate To turn off an entry, select it and click Inactivate.
Connect To connect an interface, select it and click Connect. You might use this in testing the
interface or to manually establish the connection.
Disconnect To disconnect an interface, select it and click Disconnect. You might use this in testing
the interface.
Object
References
Select an entry and click Object Reference to open a screen that shows which settings
use the entry. See Section 7.3.2 on page 122 for an example.
# This field is a sequential value, and it is not associated with any interface.
Status The activate (light bulb) icon is lit when the entry is active and dimmed when the entry is
inactive.
The connect icon is lit when the interface is connected and dimmed when it is
disconnected.
Name This field displays the name of the interface.
Extension Slot This field displays where the entry’s cellular card is located.
Connected
Device
This field displays the name of the cellular card.
ISP Settings This field displays the profile of ISP settings that this cellular interface is set to use.
Apply Click Apply to save your changes back to the ZyWALL.
Reset Click Reset to return the screen to its last-saved settings.