Filter
Top Products
Chapter 37 System
ZyWALL 110/310/1100 Series User’s Guide
460
37.7.5 Service Control Rules
Click Add or Edit in the Service Control table in a WWW, SSH, Telnet, FTP or SNMP screen to
add a service control rule.
Figure 305 Configuration > System > Service Control Rule > Edit
Edit Double-click an entry or select it and click Edit to be able to modify the entry’s
settings.
Remove To remove an entry, select it and click Remove. The ZyWALL confirms you want to
remove it before doing so. Note that subsequent entries move up by one when you
take this action.
Move To change an entry’s position in the numbered list, select the method and click Move
to display a field to type a number for where you want to put it and press [ENTER] to
move the rule to the number that you typed.
# This is the index number of the service control rule.
The entry with a hyphen (-) instead of a number is the ZyWALL’s (non-configurable)
default policy. The ZyWALL applies this to traffic that does not match any other
configured rule. It is not an editable rule. To apply other behavior, configure a rule
that traffic will match so the ZyWALL will not have to use the default policy.
Zone This is the zone on the ZyWALL the user is allowed or denied to access.
Address This is the object name of the IP address(es) with which the computer is allowed or
denied to access.
Action This displays whether the computer with the IP address specified above can access
the ZyWALL zone(s) configured in the Zone field (Accept) or not (Deny).
Authentication
Client Authentication
Method
Select a method the HTTPS or HTTP server uses to authenticate a client.
You must have configured the authentication methods in the Auth. method screen.
Apply Click Apply to save your changes back to the ZyWALL.
Reset Click Reset to return the screen to its last-saved settings.
Table 184 Configuration > System > WWW > Service Control (continued)
LABEL DESCRIPTION