Filter
Top Products
Chapter 4 Quick Setup Wizards
ZyWALL 110/310/1100 Series User’s Guide
46
Figure 27 WAN and ISP Connection Settings: (PPTP Shown)
The following table describes the labels in this screen.
Table 12 WAN and ISP Connection Settings
LABEL DESCRIPTION
ISP Parameter This section appears if the interface uses a PPPoE or PPTP Internet connection.
Encapsulation This displays the type of Internet connection you are configuring.
Authentication
Type
Use the drop-down list box to select an authentication protocol for outgoing calls.
Options are:
CHAP/PAP - Your ZyWALL accepts either CHAP or PAP when requested by this remote
node.
CHAP - Your ZyWALL accepts CHAP only.
PAP - Your ZyWALL accepts PAP only.
MSCHAP - Your ZyWALL accepts MSCHAP only.
MSCHAP-V2 - Your ZyWALL accepts MSCHAP-V2 only.
User Name Type the user name given to you by your ISP. You can use alphanumeric and -_
@$./
characters, and it can be up to 31 characters long.
Password Type the password associated with the user name above. Use up to 64 ASCII characters
except the [] and ?. This field can be blank.
Retype to
Confirm
Type your password again for confirmation.
Nailed-Up Select Nailed-Up if you do not want the connection to time out.
Idle Timeout Type the time in seconds that elapses before the router automatically disconnects from
the PPPoE server. 0 means no timeout.
PPTP Configuration This section only appears if the interface uses a PPPoE or PPTP Internet connection.
Base Interface This displays the identity of the Ethernet interface you configure to connect with a
modem or router.
Base IP Address Type the (static) IP address assigned to you by your ISP.
IP Subnet Mask Type the subnet mask assigned to you by your ISP (if given).