Filter
Top Products
D-30
Command Line Interface
Switches
/all
—Specifies whether to enable SMART configurations for
all disks.
/clear
—Clears the SMART error counts for the disk.
/enable_exceptions
—Specifies whether to enable SMART
exception reporting.
/logerr
—If FALSE (the default), logging of SMART exception
reports is dissabled. If TRUE, logging of SMART exception
reports is enabled.
/perf
—If FAL SE (the default), reporting of exceptions
according to the MRIE mode is dissabled. If TRUE, reporting of
exceptions according to the MRIE mode is enabled.
/report_count
—Number of times an exception can be
reported. A value of zero indicates no limit.
disk show default
Displays the current default for the device ID.
disk show defects [/full={
boolean
}] {device_ID}
Shows the number of defects and the defect list for a specific
drive.
Parameters
{device_ID}
—ID number of the device.
Switches
/full
—Specifies whether to display the defect count and
defects.
disk show partition
Displays all partitions on the disks attached to the currently
opened controller.
disk show smart [/all={
boolean
}] [/full={
boolean
}]
[/view_changeable={
boolean
}] {device_ID}
Displays Self-Monitoring, Analysis and Reporting Technology
(SMART) configuration information for one or all disks.