C-4
Adaptec Flash Utility (AFU)
3 Start the AFU as described in Running the AFU from the GUI on
page C-4 and follow the prompts.
Running the AFU from the GUI
The easy way to run the AFU is to use its Graphical User Interface
(GUI). If you prefer to run the AFU from the command line, see
page C-5.
To access the AFU:
1 Create the firmware floppy disks, as described in Creating the
Firmware Floppy Disks on page C-3.
2 Shut down your operating system and reboot to DOS from a
bootable MS-DOS floppy disk or from a DOS partition on a
bootable drive. (You can use the drive connected to the
controller you are updating.)
Note: When you are updating the controller flash, no I/O is
possible. Before you can use the controller again, complete
the flash operation and restart the computer.
3 At the DOS command prompt (typically
A:\>), type
AFU
with no
arguments.
The AFU’s main menu is displayed.
4
Choose
Select Controllers
and select the Adaptec RAID
controllers to be flashed.
5 Choose Select an Operation.
6 Choose any available AFU function and follow the on-screen
instructions.