Filter
Top Products
D-32
Command Line Interface
disk zero [/repair={
boolean
}] [/wait={
boolean
}]
{device_ID}
Clears an entire disk (by writing zeros). All data is erased and
cannot be recovered.
Parameters
{device_ID}
—ID number of the device to clear.
Switches
/repair
—If FALSE (the default), the command only reports
failures. If TRUE, bad blocks are automatically repaired, if
possible.
/wait
— If FAL SE (the default), the operation is performed in the
background and the command prompt is returned immediately.
If TRUE, the operation is performed immediately and the
command prompt is returned only when done.
Logfile Commands
logfile end
Ends logging of all output and closes the log file.
logfile start [/append={
boolean
}] {file}
Begins logging of all CLI command line activity to a file.
Parameters
{file}
—Name of log file.
Switches
/append
—Specifies whether to append all CLI command line
activity to an existing output file if one exists.
Task Commands
Use the CLI commands to display and manage tasks. A task is an
operation that occurs only on the controller, asynchronous to all
other operations. Examples of tasks are clearing a disk and creating
a RAID 1. Once a task is running on the controller, the CLI allows
you to display, stop, suspend, and resume the task.