Filter
Top Products
3-4
Installing the Driver
5 When prompted to install a third-party driver, press F6.
Note: When F6 is active, a prompt appears at the bottom of
the screen for only 5 seconds. If you miss your chance to
press F6, restart the computer.
6 Insert the driver floppy disk and wait until prompted to install
a driver. Press S to specify that the driver is on the floppy disk,
then press Enter. The computer reads the disk.
7 When the Adaptec driver is found, press Enter. Respond to the
on-screen instructions to complete the installation.
Installing the Driver in an Existing Windows System
To install the driver in an existing operating system:
1 Install and configure the controller and hard drives, as
described in Chapter 2.
2 Create the driver disk, as described on page 3-2. When finished,
remove the driver disk.
3 Start Windows. Windows launches the Found New Hardware
Wizard, which searches for the driver.
4 Insert the driver floppy disk, select the floppy drive as the
source, then click Next.
5 Click Next in the two subsequent windows and follow the
on-screen instructions to complete the driver installation.
6 Remove the driver disk and restart the computer.