Filter
Top Products
B-12
ACU for DOS
Channel Definition Block Keywords – SCSI only
The channel definition block is optional. If used, it always begins
with the keyword
Channel
and ends with the keyword
End
. The
channel definition block keywords are listed in the table below.
Channel Keyword
Channel is an optional keyword that begins a channel definition
block and specifies the channel number to which the channel
keywords apply. Channels are numbered from zero to the
maximum number of channels on the controller minus one.
You can include multiple channel definition blocks within a script file,
each beginning with a
Channel
keyword and value. For example:
Example
Channel=0
ControllerID Keyword
ConrollerID is an optional keyword to change the SCSI ID of the
controller. Normally, the SCSI controller is assigned SCSI ID 7 on
each of its channels. You can specify any ID value between 0 and 7.
Caution: Do not change the SCSI ID of the controller unless
directed to do so by Adaptec Technical Support.
Example
ControllerID=7
End Keyword
End
is a required keyword, indicating the end of the block.
Example
End
Keyword Description
Channel Used to identify the channel.
End Indicates the end of a channel definition block.
ControllerID Changes the SCSI ID of the controller.
!