Filter
Top Products
Chapter 7 - Using the LCD for Configuration and Management
Campus-REX2 RS Interface Card User Manual 101
2 To select the transceiver mode:
a Press Next until XCVR Mode is displayed.
b Press Enter.
c Press Next until your choice is displayed:
• Master initiates the HDSL link. The other Campus unit must
be set to Slave or Auto.
• Slave waits for the other Campus unit to initiate the HDSL
link. The other unit must be set to Master or Auto.
• Auto (default) automatically switches between Master and
Slave until an HDSL link is established.
The Transceiver Mode option determines the hierarchy of the two
Campus units when attempting to establish an HDSL link.
d Press Enter.
3 To select the HDSL rate:
a Press Next until HDSL RATE is displayed.
b Press Enter.
c Press Next until your setting choice of T1 (default), E1, or 768
is displayed.
d Press Enter.
To continue setting up the system, proceed to “Configuring the
Campus-REX2” on page 103.
Configuring Extended Mode Parameters
Set the Extended Mode parameters using the following procedure.
1 To select the Operating Mode, do one of the following:
• If the mode is set to EXTENDED, go to Step 2.
• If the mode is not set to EXTENDED, press Enter, then press Next
until the LCD displays EXTENDED, then press Enter. The
Operating Mode changes to OPERATING MODE=Extended.