Filter
Top Products
Chapter 3 - Configuring the REX2
Campus-REX2 RS Interface Card User Manual 49
Configuring RIP
From this screen, you can configure the parameters for Routing Information
Protocol (RIP) to allow the propagation of routing information. Both the Unit
(REX2 card) and Ports (LAN and Line) can be configured. See “Dynamic
Routing” on page 129 for more information about using RIP.
1 To configure RIP, from the Router Configuration screen type then
press . The RIP Configuration screen is displayed.
2 To configure RIP for the Unit (Campus-REX2), do the following:
a To enable RIP Host Routes, type then press . When
enabled, Campus-REX2 accepts host routes in RIP updates.
b To enable RIP Poison Reverse, type then press . When
enabled, this gateway (REX2) indicates to its neighbor gateways
that one of the gateways is no longer connected. It does this by
setting the number of hops to the disconnected gateway to an infinite
number of hops (16, for example).
c To enable RIP2 authentication, type then press . RIPv2
uses a plain-text password for authentication that you will set when
you change the RIP2 authentication password.
d To change the RIP2 authentication password, type then press
(RIP2 authentication must be enabled). Enter a text string of
up to 16 characters (including alphanumeric or symbols) at the
prompt:
Maximum length is 16 characters.
Enter New RIP2 Password : rex2route
2
ENTER
Jul 07, 2003 ADC TELECOMMUNICATIONS, CAMPUS RS, Version 5.1 08:19:34
Local Unit ID: Local I/F: REX2
Remote Unit ID: Remote I/F: REX2
Circuit ID:
RIP CONFIGURATION
UNIT 1) RIP Host Routes: Enabled (Disabled, Enabled)
2) RIP Poison Reverse: Enabled (Disabled, Enabled)
3) RIP2 Authentication: Disabled (Disabled, Enabled)
4) CHANGE RIP2 PASSWORD
PORTS 5) LAN RIP Receive: None (None, RIP1, RIP2, Both)
6) LAN RIP Send: None (None, RIP1, RIP2*, RIP1c*)
7) Line RIP Receive: None (None, RIP1, RIP2, Both)
8) Line RIP Send: None (None, RIP1, RIP2*, RIP1c*)
9) DYNAMIC ROUTE TABLE
*Note:
RIP2 Send = send RIP2 multicast messages
RIP1c Send = send RIP2 broadcast messages
(R)eturn (M)ain Menu
ENTER CHOICE>
1 ENTER
2 ENTER
2 ENTER
2
ENTER