Filter
Top Products
Chapter 7 - Using the LCD for Configuration and Management
104 Campus-REX2 RS Interface Card User Manual
Accessing LCD REX2 Configuration
For both bridge and router Network Protocol, the timing source and
encapsulation can be selected. For bridge mode only, Spanning Tree Protocol
can be enabled (default configuration is disabled). Use the following
procedures to set these parameters.
1 Press Escape until Campus RS I/F: REX2 is displayed.
2 Press Next twice. REX2 CONFIG & STATUS is displayed.
3 Press Enter. Configure REX2 Settings is displayed.
4 Press Enter and continue with the following sections.
Configuring REX2 Parameters
For both bridge and router Network Protocol, you can select the timing
source and encapsulation. You can then configure the specific parameters for
either bridge mode or router mode. Use the following procedures to set these
parameters.
Set the Timing Source
The Timing Source option determines the source of circuit timing on the
HDSL link and applies to both bridge and router modes. The LCD navigation
to get to this submenu was provided in the section “Accessing LCD REX2
Configuration” on page 104.
1 To select the Timing Source, do one of the following:
• If the mode is set to Timing Source, go to Step 2.
• If the mode is not set to Timing Source, press Next until the
LCD displays Timing Source, then press Enter. The Operating
Mode changes to Timing Source=Internal.
2 Press Enter. The LCD displays the current Timing Source setting
(Internal is the default).
3 Press Next until the preferred Timing Source setting is displayed, then
press Enter. The LCD displays the new Timing Source setting. Select
from the following setting options: