Filter
Top Products
Chapter 7 - Using the LCD for Configuration and Management
Campus-REX2 RS Interface Card User Manual 109
VIEWING AND CONFIGURING ALARMS
To determine if there is an active alarm condition:
1 Press Escape until CAMPUS RS I/F: REX2 is displayed.
2 Press Next three times. ALARM CONFIG & STATUS is displayed.
3 Press Enter. The LCD displays these Alarm types:
• Current Alarms HDSL
• HDSL Link Alarms Config and Status
• Local I/F Alarms Config and Status
• RMT I/F Alarms Config and Status
If a specific indicator does not display, there is no alarm in that area of
the system.
The following sections describe how to view specific alarm information for
the HDSL, local, and remote ports, and how to configure thresholds.
HDSL Alarms
This section describes how to view and configure alarms on the HDSL line.
Viewing Current Alarms
If the CURRENT ALARMS display indicates an HDSL alarm, you can
determine the alarm type:
1 From the CURRENT ALARMS display, press Next. HDSL LINK
ALARMS CONFIG & STATUS is displayed.
2 Press Enter. The current status of three alarms is displayed:
• LINK shows whether the HDSL link is on or off
• ES shows whether the errored seconds threshold has been exceeded
on the local unit, remote unit, or both
• MARGIN shows whether the margin threshold has been exceeded on
the local unit, remote unit, or both