Filter
Top Products
Chapter 3 - Configuring the REX2
Campus-REX2 RS Interface Card User Manual 33
Configuring Spanning Tree Protocol
Complete this section if you want to enable Spanning Tree Protocol (STP).
Spanning Tree Protocol is disabled as a default configuration. See “About
Spanning Tree Protocol” on page 124 for more information about the
protocol.
1 From the Bridge Configuration screen (page 3-32), type then press
. The Spanning Tree Configuration screen is displayed.
2 To enable Spanning Tree Protocol, type then press . (You can
also change the Spanning Tree option to Disabled when Enabled is
selected by typing .)
Item 10 which allows you to view Spanning Tree Status is available only
when Spanning Tree Protocol is enabled.
3 To set the Bridge Priority, type then press . At the prompt,
enter a value for the bridge priority between 0 and 65535 (default value
is 32768):
Enter New Bridge Priority : 24000
The bridge priority is set relative to other bridges in the same bridged
LAN. The spanning tree priority indicates how centrally located this
bridge is in its network. A lower number indicates a more centrally
located bridge.
2
ENTER
1 ENTER
1
Jul 07, 2003 ADC TELECOMMUNICATIONS, CAMPUS RS, Version 5.1 08:19:34
Local Unit ID: Local I/F: REX2
Remote Unit ID: Remote I/F: REX2
Circuit ID:
SPANNING TREE CONFIGURATION
UNIT 1) Spanning Tree Protocol: Enabled (Disabled, Enabled)
2) Bridge Priority: 32768 (0 - 65535)
3) Max Age (sec): 20 (6 - 40)
4) Hello Time (sec): 2 (1 - 10)
5) Forward Delay (sec): 15 (2 - 30)
PORTS 6) LAN Port Priority: 128 (0 - 255)
7) LAN Port Cost: 100 (0 - 65535)
8) Line Port Priority: 128 (0 - 255)
9) Line Port Cost: 648 (0 - 65535)
10) SPANNING TREE STATUS
(R)eturn (M)ain Menu
ENTER CHOICE>
2
ENTER