Filter
Top Products
Chapter 2 - Configuring HDSL Parameters
20 Campus-REX2 RS Interface Card User Manual
CONFIGURING HDSL PARAMETERS
Access the HDSL configuration screen, then configure parameters.
Accessing HDSL Configuration
From the Main Menu (page 14), type then press to access the
System Settings Menu.
From the System Settings Menu, type then press to access the
HDSL Parameters screen. From this screen, you can configure or change
values. Standard Mode is the default HDSL Parameters screen.
3
ENTER
Jul 07, 2003 ADC TELECOMMUNICATIONS, CAMPUS RS, Version 5.1 08:19:34
Local Unit ID: Local I/F: REX2
Remote Unit ID: Inactive Remote I/F: Inactive
Circuit ID:
SYSTEM SETTINGS MENU
1) SYSTEM PARAMETERS
2) HDSL PARAMETERS
(R)eturn
ENTER CHOICE>
2 ENTER
Jul 07, 2003 ADC TELECOMMUNICATIONS, CAMPUS RS, Version 5.1 08:19:34
Local Unit ID: Local I/F: REX2
Remote Unit ID: Inactive Remote I/F: Inactive
Circuit ID:
STANDARD MODE HDSL PARAMETERS
1) HDSL Operating Mode: Standard (Standard, Extended)
2) Transceiver Mode: Auto (Auto, Master, Slave)
3) HDSL Rate: T1 (T1, E1, 768)
Enter (S)ave to apply changes !
(S)ave (R)eturn (M)ain Menu
ENTER CHOICE>