Filter
Top Products
Chapter 3 - Configuring the REX2
Campus-REX2 RS Interface Card User Manual 63
Configuring Trap Receivers
The Campus-REX2 sends traps to devices on the network, which you
configure as trap receivers, when events or alarms occur. The following are
traps that the Campus-REX2 can issue:
• coldStart
• warmStart
• linkDown
• linkUp
• authenticationFailure
Configure the trap receivers as follows:
1 Do the following to enter an IP address and a community string for each
of three trap receivers that you can configure:
a To enter the IP address for a device on the network that will receives
traps issued by Campus-REX2, type , , or + then press
. At the prompt, enter the IP address:
Required format is nnn.nnn.nnn.nnn
Enter Trap Receiver x IP Address: 172.150.100.12
b To enter the community string for a device on the network that will
receives traps issued by Campus-REX2, type , + , or +
then press . At the prompt, enter the community string that
can be up to 64 ASCII characters:
Maximum length is 64 characters.
Enter Trap Receiver 1 Community String: rcvr1
2 Repeat Step 1 for each trap receiver you want to configure.
3 Type to return until you return to the Bridge or Router
Configuration screen.
4 If you are changing only SNMP parameters, go to “Saving the Bridge
Configuration” on page 40 or “Saving the Router Configuration” on
page 55 to save your changes.
7 9 1 1
ENTER
8 1 0 1 2
ENTER
R