Filter
Top Products
Chapter 3 - Configuring the REX2
60 Campus-REX2 RS Interface Card User Manual
CONFIGURING THE CAMPUS-REX2 FOR SNMP
M
ANAGEMENT
SNMP protocol provides a way for HP OpenView or an Element
Management System (EMS) such as StarGazer to manage the Campus-REX2
system over a network. A Campus-RS Management Unit (CMU), installed
into a Campus-Star chassis, provides SNMP management for components in
the chassis and for management of elements attached to the chassis (desktop
units or units in other Campus-Star chassis). The EMS can directly manage a
Campus-REX2 that is in a desktop unit or a Campus-Star chassis.
You can also set the Campus-REX2 to perform authentication error trap
generation. To enable this feature, do the following:
• Set the Authentication Trap Status to Enabled or Disabled.
• Enter an IP Address for each Trap Receiver.
• Enter a community string for each Trap Receiver.
Accessing the SNMP Configuration
1 From the Main Menu (page 1-14), type then press to access
the REX2 Configuration and Status screen.
2 ENTER
Jul 07, 2003 ADC TELECOMMUNICATIONS, CAMPUS RS, Version 5.1 08:19:34
Local Unit ID: Southall Quad 4 Local I/F: REX2
Remote Unit ID: Central Remote I/F: REX2
Circuit ID: Southeast line 421
REX2 CONFIGURATION AND STATUS
LAN STATUS: 100BaseT, Full Duplex, Up
LINE STATUS: Standard, Auto, T1, Up
MAC ADDRESS: 00:20:A7:01:02:08
1) Network Protocol: Bridge (Bridge, Router)
2) Encapsulation: cHDLC (cHDLC, PPP)
3) Timing Source: Internal (Internal, HDSL)
4) BRIDGE CONFIGURATION
5) BRIDGE STATISTICS
6) SNMP CONFIGURATION
7) SAVE REX2 CONFIGURATION
WARNING: Configuration change(s) will be lost if not saved before
resetting or powering unit down.
(R)eturn
ENTER CHOICE>