Filter
Top Products
Chapter 7 - Using the LCD for Configuration and Management
108 Campus-REX2 RS Interface Card User Manual
4 To change the parameter, press Enter when the parameter is displayed
(the current setting of this parameter displays on a separate screen).
5 Press Next until the desired (new) setting is displayed, then press Enter.
6 Press Escape to return to the Router Configuration menu.
Viewing DHCP Service. Complete this section to view the configured
parameter for DHCP service. These parameters must be configured through
the terminal screens. The LCD navigation to get to this submenu was
provided in the section “Accessing LCD REX2 Configuration” on page 104.
1 Press Next until you select Router Configuration, then press Enter.
2 Press Next until you select DHCP Service, then press Enter.
None is the default configuration. You can select DHCP Relay through
the terminal screen. The configured value is displayed.
3 Press Escape to return to the Router Configuration menu.
Saving the REX2 Configuration
If you have changed the Campus-REX2 Bridge or Router configuration, you
can save this configuration. To save the configuration:
1 Press Next until Press ENTER to save REX2 config is
displayed.
2 Press Enter. REX2 CONFIG SAVE IN PROGRESS is displayed.
3 After a pause, REX2 CONFIG SAVE COMPLETE is displayed.
4 Press Next to return to the previous screen.
RESTORING THE SYSTEM TO DEFAULT VALUES
You can restore all of the configuration options to their factory default values.
To return the system configuration options to their default values:
1 Press Escape until CAMPUS RS I/F: REX2 is displayed.
2 Press Enter. S/W VERSN and S/WCKSUM is displayed.
3 Press Next six times. Press ENTER to factory reset is
displayed.
4 Press Enter. The system configuration options return to the
default values.