Filter
Top Products
Chapter 3 - Configuring the REX2
Campus-REX2 RS Interface Card User Manual 47
The Dynamic Route (created by RIP) and ARP tables are dynamically built
and can be accessed from this screen. The Static Route table is built from
routes that you manually configure. For information about these routing
tables, see:
• “Viewing the Dynamic Routing Table” on page 59
• “Viewing the ARP Table” on page 42
• “Managing the Static Routing Table” on page 57
Configuring the IP Addresses
You can configure IP addresses and subnet masks for both the Line and
LAN ports as well as configure a default gateway for packets to be routed to
the Internet if the next hop cannot be identified. See “Campus-REX2 IP
Addresses” on page 129 for more information.
1 To configure the IP address and subnet masks, type then press
. The IP Address Configuration screen is displayed.
2 To set the LAN IP address and subnet mask, type then press .
At the prompt, enter the LAN IP address and subnet mask for the
Campus-REX2 LAN port.
Required format is nnn.nnn.nnn.nnn
Enter LAN IP Address: 10.0.0.1
Enter Subnet Mask (<CR> only=default Mask
255.0.0.0): 255.0.0.0
1
ENTER
Jul 07, 2003 ADC TELECOMMUNICATIONS, CAMPUS RS, Version 5.1 08:19:34
Local Unit ID: Local I/F: REX2
Remote Unit ID: Remote I/F: REX2
Circuit ID:
IP ADDRESS CONFIGURATION
1) LAN IP Address: 192.168. 1. 1
LAN Subnet Mask: 255.255.255. 0
2) Line IP Address: 0. 0. 0. 0
Line Subnet Mask: 255. 0. 0. 0
3) Default Gateway: 0. 0. 0. 0
(R)eturn (M)ain Menu
ENTER CHOICE>
1 ENTER