Filter
Top Products
Campus-REX2 RS Interface Card User Manual 19
2
CONFIGURING
HDSL PARAMETERS
Campus units have a default HDSL configuration to operate in Standard
Mode with a T1 (1.544 Mbps) HDSL Rate. This default configuration is
compatible with other Campus-RS and Campus-HRS products (including the
Campus-T1 desktop units and line units) if you choose to operate them in
their default configuration.
You can also configure the HDSL parameters through the LCD menus.
See “Using the LCD for Configuration and Management” on page 7-97
for instructions on using the LCD panel. To view system performance and
other status information, see “Monitoring and Testing the Campus System”
on page 5-73.
For: See Page:
Configuring HDSL Parameters 20
Configuring HDSL Alarms 26
Changes to the HDSL operating mode or transmission rate are
not automatically made to the remote unit. These changes
must be made at both the local and remote units for the HDSL
link to be re-established. If the remote unit is not easily
accessible, you can follow the instructions in “Logging On a
Remote Campus Unit” on page 1-15 to use a PC for a remote
logon (if an HDSL link is up) and make the preferred change.
When you change the HDSL settings on the remote unit, the
HDSL link is lost; it is re-established when you make the
identical change(s) on the local unit.