Filter
Top Products
Chapter 3 - Configuring the REX2
50 Campus-REX2 RS Interface Card User Manual
3 To configure RIP for the LAN and Line ports, do the following:
a To select the version of RIP packets that will be received by the
LAN port, type then press . Repeat until the preferred RIP
version is selected:
• None indicates that a RIP version is not selected.
• RIP1 indicates that only RIPv1 packets will be received by the
LAN port.
• RIP2 indicates that only RIPv2 packets will be received by the
LAN port.
• Both indicates that both RIPv1 and RIPv2 packets will be
received by the LAN port.
b To select the version of RIP packets that will be sent by the LAN
port, type then press . Repeat until the preferred RIP
version is selected:
• None indicates that a RIP version is not selected.
• RIP1 indicates that only RIPv1 packets will be sent by the LAN
port.
• RIP2 indicates that RIPv2 multicast packets will be sent by the
LAN port.
• RIP1c indicates the RIPv2 broadcast messages will be sent by
the LAN port.
c To select the version of RIP packets that will be received by the Line
port, type then press . Repeat until the preferred RIP
version is selected:
• None indicates that a RIP version is not selected.
• RIP1 indicates that only RIPv1 packets will be received by the
Line port.
• RIP2 indicates that only RIPv2 packets will be received by the
Line port.
• Both indicates that both RIPv1 and RIPv2 packets will be
received by the Line port.
5 ENTER
6 ENTER
7 ENTER