Filter
Top Products
AT-S63 Management Software Menus User’s Guide
Section I: Basic Operations 103
Deleting a Community String
To delete an SNMPv1 or SNMPv2c community string, perform the
following procedure:
1. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 1 on page 32.
2. From the System Administration menu, type 5 to select SNMP
Configuration.
The SNMP Configuration menu is shown in Figure 26 on page 94.
3. From the SNMP Configuration menu, type 3 to select Configure
SNMPv1 &SNMPv2c Community.
The Configure SNMPv1 &SNMPv2c Community menu is shown in
Figure 27 on page 96.
4. From the Configure SNMPv1 &SNMPv2c Community menu, type 2 to
select Delete SNMP Community. This prompt is displayed:
Enter Trap Receiver IP Addr:
5. Enter the community string to be deleted. Community strings are case
sensitive. A confirmation prompt is displayed.
6. Type Y for yes to delete the string or N for no to cancel the procedure.
If you selected yes, the community string is immediately deleted from
the switch.
7. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.