Filter
Top Products
Chapter 36: TACACS+ and RADIUS Protocols
642 Section IX: Management Security
Configuring the TACACS+ Client
To configure the TACACS+ client on the switch, perform the following
procedure:
1. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 1 on page 32.
2. From the System Administration menu, type 6 to select Authentication
Configuration.
The Authentication Configuration menu is shown in Figure 238 on
page 640.
3. From the Authentication Configuration menu, type 3 to select
TACACS+ Configuration.
The TACACS+ Client Configuration menu is shown in Figure 239.
Figure 239. TACACS+ Client Configuration Menu
4. Adjust the following parameters as necessary.
1 - TAC Server 1
2 - TAC Server 2
3 - TAC Server 3
Use these parameters to specify the IP addresses of up to three
network servers containing TACACS+ server software. After you have
entered an IP address, you will see the following prompt:
Use per-server secret [Y/N] ->
Allied Telesis AT-9424T/SP - AT-S63
Marketing
User: Manager 11:20:02 02-Mar-2005
TACACS+ Client Configuration
1 - TAC Server 1 .................. 0.0.0.0
2 - TAC Server 2 .................. 0.0.0.0
3 - TAC Server 3 .................. 0.0.0.0
4 - TAC Global Secret .............
5 - TAC Timeout ................... 30 seconds
R - Return to Previous Menu
Enter your selection?