Filter
Top Products
Chapter 1: Basic Switch Parameters
50 Section I: Basic Operations
Returning the AT-S63 Management Software to the Factory Default
Values
The procedure in this section returns all AT-S63 Management Software
parameters to the default values. Please note the following before you
perform this procedure:
Returning all parameter settings to their default values also deletes all
routing interfaces as well as all port-based and tagged VLANs on the
switch.
This procedure does not delete files from the AT-S63 file system. To
delete files, refer to Chapter 9, ”File System” on page 145.
This procedure does not delete any encryption keys stored in the key
database. To delete encryption keys, refer to “Deleting an Encryption
Key” on page 600.
Returning a switch to its default values does not alter the contents of
the active boot configuration file. To reset the file back to the default
settings, you must reestablish your management session after the
switch reboots and then select Save Configuration changes.
Otherwise the switch reverts back to the previous configuration the
next time you reset the switch.
Note
The AT-S63 Management Software default values are listed in the
AT-S63 Management Software Features Guide.
To return the AT-S63 Management Software to the default settings,
perform the following procedure:
1. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 1 on page 32.
2. From the System Administration menu, type 9 to select System
Utilities.
The System Utilities menu is shown in Figure 6 on page 43.
3. From the System Utilities menu, type 4 to select Reset to Factory
Defaults.
The following prompt is displayed:
This operation requires a switch reboot? [Yes/No] ->
4. Type Y for yes or N to cancel the procedure.