Filter
Top Products
Chapter 21: SNMPv3
340 Section IV: SNMPv3
Configuring the SNMPv3 Access Table
This section contains a description of the SNMPv3 Access Table and how
to create, delete, and modify table entries. The SNMPv3 Access Table
allows you to configure a security group. Each user must belong to a
security group. After you have configured a security group, use the
SecurityToGroup Table to assign users to security groups. See “Creating
an SNMPv3 SecurityToGroup Table Entry” on page 356.
For each security group, you can assign the following attributes:
a Security Model (SNMPv1, SNMPv2c, SNMPv3)
Read, write, and notify views
A security level
A storage type
Before you begin this procedure, you will need to configure entries in the
View Table. These values are used to configure the Read, Write, and
Notify View parameters in this procedure. See “Configuring the SNMPv3
View Table” on page 331.
There are three functions you can perform with the SNMPv3 Access
Table.
“Creating an SNMPv3 Access Table Entry,” next
“Deleting an SNMPv3 Access Table Entry” on page 344
“Modifying an SNMPv3 Access Table Entry” on page 346
Creating an
SNMPv3 Access
Table Entry
To create an entry in the SNMPv3 Access Table, perform the following
procedure.
1. Display the Configure SNMPv3 Table menu by performing steps 1
through 3 in “Configuring the SNMPv3 User Table” on page 321. Or,
from the Main Menu type 5->5->5.
The Configure SNMPv3 Table menu is shown in Figure 126 on page
322.
2. From the Configure SNMPv3 Table menu, type 4 to select Configure
SNMPv3 Access Table.