Filter
Top Products
AT-S63 Management Software Menus User’s Guide
Section IV: SNMPv3 391
When you modify the Security Name parameter, you must use a value that
you configured with the User Name parameter in the Configure SNMPv3
User Table menu. If you do not use a value configured with the User Name
parameter, messages are not sent on behalf of this User Name. See
“Creating an SNMPv3 User Table Entry” on page 321.
To modify the Security Name parameter in an SNMPv3 Target Parameter
Table entry, perform the following procedure.
1. Display the Configure SNMPv3 Table menu by performing steps 1
through 3 in “Configuring the SNMPv3 User Table” on page 321. Or,
from the Main Menu type 5->5->5.
The Configure SNMPv3 Table menu is shown in Figure 126 on page
322.
2. From the Configure SNMPv3 Table menu, type 8 to select Configure
SNMPv3 Target Address Table.
The Configure SNMPv3 Target Parameters Table menu is shown in
Figure 139.
3. From the Configure SNMPv3 Target Parameters Table menu, type 3 to
select Modify SNMPv3 Table Entry.
The Modify SNMPv3 Target Parameters Table menu is shown in
Figure 140.
Figure 140. Modify SNMPv3 Target Parameters Table Menu
Allied Telesis AT-9424T/SP - AT-S63
Marketing
User: Manager 11:20:02 02-Mar-2005
Modify SNMPv3 Target Parameters Table
Target Parameters Name ... host27
Message Processing Model . v3
Security Model............ v3
Security Name ............ hoa
Security Level ........... AuthNoPriv
Storage Type ............. NonVolatile
Row Status ............... Active
1 - Set Security Name
2 - Set Security Model
3 - Set Security Level
4 - Set Message Processing Model
5 - Set Storage Type
U - Update Display
R - Return to Previous Menu
Enter your selection?