Filter
Top Products
AT-S63 Management Software Menus User’s Guide
Section I: Basic Operations 133
5. Type 1 to select Aggregator and, when prompted, enter the name of
the aggregator to be modified. The name is case-sensitive. (To display
the names of the aggregators on a switch, refer to “Displaying LACP
Port and Aggregator Status” on page 135)
After you enter the aggregator’s name, the specifications of the
aggregator are displayed in the menu.
6. Configure the following parameters as necessary:
Note
You cannot modify the name or adminkey of an aggregator. If you
need to change an aggregator’s name or adminkey, you must delete
the aggregator and recreate it.
3 - Distribution Mode
Sets the load distribution method. Possible settings are:
SRC MAC - Source MAC address
DST MAC - Destination MAC address
SRC/DST MAC - Source address /destination MAC address
SRC IP - Source IP address trunking
DST IP - Destination IP address trunking
SRC/DST IP - Source address /destination IP address
The default is SRC/DST MAC.
4 - Port Range
Specifies the aggregator ports. An aggregator can contain any number
of ports on the switch. You can identify the ports individually (for
example, 3,7,10), as a range (for example, 5-11), or both (for example,
2,4,11-14).
7. After configuring the parameters, type M to select Modify Aggregator.
The aggregator is modified on the switch.
8. To permanently save your change, return to the Main Menu and type S
to select Save Configuration Changes.
9. Reconnect the cables to the ports of the aggregator.
The modified aggregator is now ready for network operations.