Filter
Top Products
User's Guide
Solving Problems 6-19
Table 6-1. Troubleshooting Guide––continued
Symptom Probable Cause/Corrective Action
Characters overlap each other or
99
99
9 CELL setting on Setup menu
there are wide gaps between them. is incorrect; check setting.
Double-high text overlaps text
99
99
9 Leave a blank line after every
on the next line. double-high line of text.
Double-wide characters overlap.
99
99
9 Leave a blank space after every
double-wide character.
Foreign symbols replace some of
99
99
9 LANG setting on Setup menu
the standard ASCII characters. is incorrect; check setting.
Vertical line drawing and compo-
99
99
9 DIRCTN setting on Setup menu
nent characters do not align. is bi-directional; change setting
to uni-directional.
Printing only occurs from left to
99
99
9 DIRCTN setting on Setup menu
right, not in both directions. is uni-directional; change setting
to bi-directional.
Some of the IBM graphics char-
99
99
9 SETS setting on Setup menu
acters do not print or print as is incorrect; check setting.
italic characters.
Printing is not in color.
99
99
9 Color ribbon cartridge is not
installed.
Printing continues to physical
99
99
9 PGE END setting on Setup
bottom edge of page on cut sheets, menu is off; change setting
intead of using LENG setting. to on.
Printer not leaving blank lines (los-
99
99
9 PGE END setting on Setup
ing line feed) at top of cut sheets. menu is off; change setting
to on.
User's Guide
Solving Problems 6-19
Table 6-1. Troubleshooting Guide––continued
Symptom Probable Cause/Corrective Action
Characters overlap each other or
99
99
9 CELL setting on Setup menu
there are wide gaps between them. is incorrect; check setting.
Double-high text overlaps text
99
99
9 Leave a blank line after every
on the next line. double-high line of text.
Double-wide characters overlap.
99
99
9 Leave a blank space after every
double-wide character.
Foreign symbols replace some of
99
99
9 LANG setting on Setup menu
the standard ASCII characters. is incorrect; check setting.
Vertical line drawing and compo-
99
99
9 DIRCTN setting on Setup menu
nent characters do not align. is bi-directional; change setting
to uni-directional.
Printing only occurs from left to
99
99
9 DIRCTN setting on Setup menu
right, not in both directions. is uni-directional; change setting
to bi-directional.
Some of the IBM graphics char-
99
99
9 SETS setting on Setup menu
acters do not print or print as is incorrect; check setting.
italic characters.
Printing is not in color.
99
99
9 Color ribbon cartridge is not
installed.
Printing continues to physical
99
99
9 PGE END setting on Setup
bottom edge of page on cut sheets, menu is off; change setting
intead of using LENG setting. to on.
Printer not leaving blank lines (los-
99
99
9 PGE END setting on Setup
ing line feed) at top of cut sheets. menu is off; change setting
to on.