Filter
Top Products
User's Guide
Control Panel 4-17
Select Power-On Default Settings
DFALT lets you select the printer settings to use as the power-on default
settings. You can select the factory settings or the settings you saved
previously with a SAVE operation. The printer keeps your DFALT
selection in non-volatile memory so it is retained when the printer is off.
You can select Fctry to use the factory settings as the power-on defaults;
or Usr 1 through Usr 5 to use the settings saved under one of these
names.
Run Printer Tests
TEST lets you run a variety of printer tests, including a memory check,
ribbon alignment test, serial loopback test, and a sensor check. If a test
is unsuccessful, an error message appears to notify you.
You can select None, which is always the default and does not perform
any test; Memory, which checks the printer memory; Ribbon, which
performs a ribbon alignment print test; Serial, which checks the serial
interface; and Sensor, which runs the sensor check. Printer tests are
described in detail in the Solving Problems section of this guide.
3) DFALT: Fctry
4) TEST: None
SETUP
MENU
I
O
User's Guide
Control Panel 4-17
Select Power-On Default Settings
DFALT lets you select the printer settings to use as the power-on default
settings. You can select the factory settings or the settings you saved
previously with a SAVE operation. The printer keeps your DFALT
selection in non-volatile memory so it is retained when the printer is off.
You can select Fctry to use the factory settings as the power-on defaults;
or Usr 1 through Usr 5 to use the settings saved under one of these
names.
Run Printer Tests
TEST lets you run a variety of printer tests, including a memory check,
ribbon alignment test, serial loopback test, and a sensor check. If a test
is unsuccessful, an error message appears to notify you.
You can select None, which is always the default and does not perform
any test; Memory, which checks the printer memory; Ribbon, which
performs a ribbon alignment print test; Serial, which checks the serial
interface; and Sensor, which runs the sensor check. Printer tests are
described in detail in the Solving Problems section of this guide.
3) DFALT: Fctry
4) TEST: None
SETUP
MENU
I
O