Filter
Top Products
User's Guide
Loading Paper 3-5
Loading Forms––continued
)Note: To load sheets wider than 16 inches, don't use the paper edge
guides. Just set a sheet into the paper entry slot behind the platen and let
it rest against the paper support. If necessary, you can remove the edge
guides.
,Caution: When loading a cut sheet, do not turn off or reset the printer
until the sheet is capture under the bail. If you do, a paper jam may
result during the next form feed.
You can load forms with pin-fed report paper already loaded, provided
that the pin-fed report paper is in the parked position. You'll learn more
about paper park later in this section.
Positioning a Form
If necessary, you can reposition a form after loading it. To do so, press
the Ready button to disable printing. Then, turn the Select-dial either
clockwise to advance the form or counterclockwise to reverse feed the
form. Then, press the Ready button again to enable printing.
Ejecting a Form
The printer ejects a form under any of the following conditions:
99
99
9 When instructed by your software application.
99
99
9 When printing reaches the last print line on the form.
99
99
9 When printing reaches the number of lines you or your software
application specified for a form.
99
99
9 When automatic form feeding is on and printing reaches a half-inch
from the bottom of the page.
99
99
9 When you press the Form Feed button on the control panel.
User's Guide
Loading Paper 3-5
Loading Forms––continued
)Note: To load sheets wider than 16 inches, don't use the paper edge
guides. Just set a sheet into the paper entry slot behind the platen and let
it rest against the paper support. If necessary, you can remove the edge
guides.
,Caution: When loading a cut sheet, do not turn off or reset the printer
until the sheet is capture under the bail. If you do, a paper jam may
result during the next form feed.
You can load forms with pin-fed report paper already loaded, provided
that the pin-fed report paper is in the parked position. You'll learn more
about paper park later in this section.
Positioning a Form
If necessary, you can reposition a form after loading it. To do so, press
the Ready button to disable printing. Then, turn the Select-dial either
clockwise to advance the form or counterclockwise to reverse feed the
form. Then, press the Ready button again to enable printing.
Ejecting a Form
The printer ejects a form under any of the following conditions:
99
99
9 When instructed by your software application.
99
99
9 When printing reaches the last print line on the form.
99
99
9 When printing reaches the number of lines you or your software
application specified for a form.
99
99
9 When automatic form feeding is on and printing reaches a half-inch
from the bottom of the page.
99
99
9 When you press the Form Feed button on the control panel.