Filter
Top Products
Printing 11-15
supported length restriction of 38”. The label shown on the screen is
over 38” long. Note that the display indicates the cutoff point at 38”.
If you attempt to print this label as it is, the printer truncates the job at
the maximum length of 38”, without displaying a warning message. The
part of the circle that extends beyond 38” does not print, just as shown
on the display screen.
Non-truncating conditions
You see the actual set label length on your display screen, and the
system will not automatically truncate a label that exceeds the
maximum length allowed for the supplies installed, under these
conditions:
When you create a label with continuous color ribbon installed, with
single color objects, unless the objects you added to the label extend
beyond the 100” maximum length for this type print job.
When the length is set for the label, either by you when you create
the label, or by the template you used to create the label.
When you save your label, then retrieve it again with a panel ribbon
installed, you will see the actual set label length indicated on the
screen.
In these cases, when you attempt to print the label, the system displays
a Label Too Long message, and you must correct the label before
proceeding.
Cut out label length
The maximum length for cut out labels is 38” or 965 mm. See
CHAPTER 10: Working with Cut-outs, beginning on page 10-1, for
more information about cut out labels.