Filter
Top Products
Cutter Maintenance B-5
Step 2: Hold the stylus holder as shown here to make the adjustment:
Figure B-3. Adjusting the stylus depth.
Step 3: Note the dots beneath the adjustment dial. Each dot represents an
adjustment of approximately .001 inch (.0025 mm).
Start by turning the adjustment dial past one dot.
Turn the dial clockwise to increase the cutting depth.
Turn the dial counter-clockwise to decrease the cutting depth.
Step 4: Test the stylus before re-installing it:
1. Take a sample piece of the installed tape, and place it flat on a hard
surface.