Filter
Top Products
Software Conventions 1-5
Introduction
IP Address
Displays the deviceÕs IP (Internet Protocol) Address; this will be the IP address
used to deÞne the device icon. The IP address is assigned via Local Management
to the CSXÕs internal Host interface; it cannot be changed via SPECTRUM
Element Manager.
Location
Displays the user-deÞned location of the device. The location is entered through
the System Group window; see the Generic SNMP UserÕs Guide for details.
MAC Address
Displays the manufacturer-set MAC address associated with the IP address used
to deÞne the device icon; this will be the MAC address assigned to the CSXÕs
internal Host interface. Note that each physical interface in the CSX has its own
MAC address; these addresses are factory-set and cannot be altered.
Using the Mouse
This document assumes you are using a Windows-compatible mouse with two
buttons; if you are using a three button mouse, you should ignore the operation of
the middle button when following procedures in this document. Procedures
within the SPECTRUM Element Manager document set refer to these buttons as
follows:
Figure 1-2. Mouse Buttons
For many mouse operations, this document assumes that the left (primary) mouse
button is to be used, and references to activating a menu or button will not
include instructions about which mouse button to use.
However, in instances in which right (secondary) mouse button functionality is
available, instructions will explicitly refer to right mouse button usage. Also, in
situations where you may be switching between mouse buttons in the same area
or window, instructions may also explicitly refer to both left and right mouse
buttons.
Left Mouse Button
Right Mouse Button