Filter
Top Products
Finisher-AE1/Saddle Finisher-AE2/Puncher Unit-M1
3-32
3
Optional Equipment
a Top Cover of the Finisher
Open this cover to remove jammed paper. (See
"Inside the Top Cover of the Finisher-AE1/
Saddle Finisher-AE2 (Optional)," on p. 8-53.)
b Top Cover of the Puncher Unit-M1
Open this cover to remove jammed paper. (See
"Puncher Unit-M1 (Optional)," on p. 8-65.)
c Front Cover of the Punch Waste Tray
Open this cover to remove punch waste or to
remove jammed paper. (For instructions on
removing punch waste, see "Removing Punch
Waste," on p. 7-43. For instructions on clearing a
paper jam, see "Puncher Unit-M1 (Optional)," on
p. 8-65.)
d Buffer Pass Unit-E2
Open the Buffer Pass Unit-E2 to remove jammed
paper. (See "Inside the Buffer Pass Unit-E2 of
the Finisher-AE1/Saddle Finisher-AE2
(Optional)," on p. 8-56.)
e Front Cover of the Finisher-AE1
Open this cover to replace the staple cartridge in
the stapler unit, or to clear a staple jam. (For
instructions on replacing the staple cartridge,
see "Replacing the Staple Cartridge in the
Stapler Unit," on p. 7-36. For instructions on
clearing a staple jam, see "Finisher-AE1/Saddle
Finisher-AE2 (Optional)," on p. 8-78.)
f Front Cover of the Saddle Finisher-AE2
Open this cover to replace the staple cartridge,
remove jammed paper, or to clear a staple jam in
the stapler unit and saddle stitcher unit. (For
instructions on replacing the staple cartridge in
the stapler unit, see "Replacing the Staple
Cartridge in the Stapler Unit," on p. 7-36. For
instructions on replacing the staple cartridge in
the saddle stitcher unit, see "Replacing the
Staple Cartridge in the Saddle Stitcher Unit," on
p. 7-40. For instructions on clearing a paper jam,
see "Inside the Front Cover of the Saddle
Finisher-AE2 (Optional)," on p. 8-58, and
"Saddle Stitcher Unit (Optional)," on p. 8-61. For
instructions on clearing a staple jam in the
stapler unit, see "Finisher-AE1/Saddle
Finisher-AE2 (Optional)," on p. 8-78. For
instructions on clearing a staple jam in the
saddle stitcher unit, see "Saddle Stitcher Unit
(Optional)," on p. 8-81.)
g Booklet Tray (Saddle Finisher-AE2 Only)
Prints that are saddle stitched are output to this
tray.
h Booklet Tray Guide (Saddle
Finisher-AE2 Only)
Set this guide to match the size of the output
paper. (See "Finishing Modes," on p. 3-33.)
i Lower Output Tray
Prints are output to this tray. You can set the Tray
Designation mode to designate this tray for
outputting prints when using certain functions.
(See "Output Tray Designation," on p. 4-37.)
j Upper Output Tray
Prints are output to this tray. You can set the Tray
Designation mode to designate this tray for
outputting prints when using certain functions.
(See "Output Tray Designation," on p. 4-37.)