Filter
Top Products
Specifying Common Settings
4-36
4
Customizing Settings
Energy Consumption in the Sleep Mode
You can set the amount of energy that the machine consumes when it is in the
Sleep mode.
NOTE
•
The machine may not enter the Sleep mode completely, depending on the status and
type of installed MEAP applications (e.g., there still may be applications running in the
background consuming power).
•
If there are less than 10 minutes remaining before a Delayed Send job is to be sent, the
machine will not enter the Sleep mode completely.
•
If you are using a management application (such as NetSpot Console) to view or
manage the settings and status of the machine via the network, the machine may not
enter the Sleep mode completely.
•
If you are using the machine as a Windows printer, the machine may not enter the Sleep
mode completely if SNMP Status is enabled for your operating system (unless your
computer is turned OFF). For more information on disabling SNMP Status, contact your
network administrator.
•
In some cases, the energy consumption level in the Sleep mode is 'High' even when the
energy consumption level is set to 'Low' when:
- A job is being processed (including a forwarding job, report job, receive job, and
sending a forwarding done notice).
- Any of the following settings are set from the Additional Functions screen:
*1 If there is more than 10 minutes remaining before the specified time, the machine consumes the same amount
of energy as when the energy consumption level is set to 'Low'.
Report Settings
Settings Send The Daily Activity Report Time setting for
the Activity Report is set to 'On'.
*1
Fax The Daily Activity Report Time setting for
the FAX Activity Report is set to 'On'.
*1
System Settings
Communications
Settings
Memory RX Inbox
Settings
Time limit for receiving fax documents in
memory is set.
*1
Network Settings TCP/IP Settings DHCP is set to 'On'.
NetWare Settings NetWare is set to 'On'.
AppleTalk Settings AppleTalk is set to 'On'.
SMB Settings SMB is set to 'On'.
E-Mail/I-Fax The POP Interval setting is set to less
than '10' minutes (except when the POP
Interval setting is set to '0').