Filter
Top Products
D. Pick-up PCB
1) Remove the pick-up unit following steps
1-7 on Page 3-9.
2) Disconnect the 6 connectors.
3) Remove the screw, disconnect the 2
claws, and take out the pick-up PCB.
➀ Connectors ➁ Screw
➂ Claws ➃ Pick-up PCB
Figure 3-8-7
E. Multi-purpose Tray PCB
1) Remove the multi-purpose tray pick-up
unit following steps 1-6 on Page 3-12.
2) Remove the multi-purpose tray pick-up
unit fan following steps 2-3 on Page 3-
40.
3) Remove the multi-purpose tray pick-up
clutch following steps 2-3 on Page 3-32.
4) Disconnect the 2 connectors
➀ Connector
Figure 3-8-8
5) Remove the spring and then the lifting
plate position detection arm.
➀ Spring
➁ Lifting plate position detection arm
Figure 3-8-9
3 - 44
CHAPTER 3
➀
➀
➁
➃
➀
➂
➀
➁
➀