Filter
Top Products
A - 12
APPENDIX
RESETTING PRINT-
ER
RESTORING
DEFAULTS
MEMORY OVER-
FLOW
READY
MRT COMPRES-
SION
+ FORMAT DISK\
- IGNORE DISK
+ REALLY FORMAT
- IGNORE DISK
START DISK TEST
ENTER ENDS TEST
FORMATTING...
DSK FMT RESTART
-envsize
Displays when TEST/RESET PRINTER item is
selected
Displays when TEST/FACTORY DEFAULTS
item is selected.
Memory overflow. The printer received more
data than it can fit into its available memory.
This can happen if too many soft fonts,
macros, or graphics which are too complex are
received.
Printer has invoked MRT Compression
because of lossy compression.
Either a request has been made to format the
disk or the printer has determined that the
disk needs formatting (engin a new unformat-
ted disk is installed when power up).
The operator is being asked to verify the disk
formatting is really wanted.
This is in response to the foregoing message.
Start testing the hard disk
Stop testing the hard disk
This message displays when the disk is being
formatted.
The operator has formatted the disk and the
operation has completed. The system will
No action required
No action required.
The job will resume after 10 sec-
onds if AUTOCONT is ON.
Otherwise press the Continue key
to resume printing. Check the
page that ejects since the page
could not be processed as
requested. Also simplify the job or
add additional memory.
No action required.
Press + to format the disk or press
- to ignore the disk.
For new/unformatted disk: If
press - to ignore disk, the printer
goes to "READY".
Any attempt to write to the
disk will be flushed since the disk
has not been formatted.
Press + to verify that the disk is to
be formatted or press - to skip
formatting the disk. This message
will not display for new/unfor-
matted disk (engin. The disk is to
be formatted for the 1st time)
Press Enter to start disk testing.
Note: This operation will cause
the disk to format when
press enter to end test. If
the printer is powered off
during the disk test, the
message + FORMAT
DISK \ - IGNORE DISK
will appear when the
printer is powered on.
Press Enter to end disk testing.
Note: The disk will be format-
ted and the printer will
reboot automatically
when press Enter to end
disk test.
No action required.
Press the Continue key for the
printer to reboot.
Message
Meaning
Action