Filter
Top Products
New Zealand
C-3
C
Country-Specific Features
New Zealand
Telecom FaxAbility
In New Zealand, Telecom N.Z. offers the FaxAbility capability. This service allows you to assign two
numbers to your line: one for fax and one for telephone. When the fax number is called, the network
sends a specific ring tone which your unit recognises and automatically handles as a fax call. If the
telephone number is called, a different ring tone is sent out from the network so that the call is handled
as a voice call. This means that there is no switching delay at the caller’s end.
Contact Telecom for connection information.
Setting the FAX-L380S/L390 for Network Switch
Follow this procedure to set the receive mode to NET SWITCH:
1
Open One-Touch Speed Dial panel ➞ press [Receive Mode].
The LCD display shows the current receive mode setting.
2
Press [Receive Mode] repeatedly until the [NET SWITCH] appears ➞ press [OK].
Network Switch System Operation
The procedure for using the network switch system is almost the same as when using the FAX over a
normal telephone line. When you receive calls, however, the unit will respond slightly differently as
described below:
■ When you hear the telephone call ring pattern:
Pick up the handset and talk normally. If you hear a slow beep, it means the call is from a fax machine
trying to send a fax. Press [Start] to receive the fax. If you do not pick up the handset, the unit
continues to ring until the other party hangs up. If an answering machine is connected, it takes over the
call.
■ When you hear the fax call ring pattern:
After the unit rings, it receives the document automatically.