Filter
Top Products
9-22
Configuration Guide for Cisco Secure ACS 4.2
OL-14390-02
Chapter 9 NAC Configuration Scenario
Step 5: Set Up Shared Profile Components
To enable dACLs and NAFs, which are required to create NAPs:
• Add a new posture ACL.
• Add ACE entries for the ACL.
• Save the posture ACL.
Note These ACLs are referred to as posture ACLs because they are a component of a NAP that is used in
posture validation.
Adding an ACL
To add a new ACL:
Step 1 Choose Shared Profile Components > Downloadable IP ACLs.
A list of dACLs appears, as shown in Figure 9-12:
Figure 9-12 Downloadable IP ACL List
Step 2 Click Add.
The Edit Downloadable IP ACLs page opens, as shown in Figure 9-13.